New Power Grid Stabilization (PGS) Module For Sale in Georgia – Yancey Bros. Co.
Yancey Brands
Hotlines
Power Grid Stabilization (PGS) module
Power Grid Stabilization (PGS) module

The Cat® PGS module is a scalable, rapidly deployable energy storage system. The PGS integrates with solar or other renewable sources to provide short duration power when the renewable source is not available or virtual spinning reserve to optimize generator sets efficiency. This system provides temporary backup power to facilities in the event of a power outage.

Get Pricing
Call 877-OWNACAT
Technical Summary
Application Transient Assist
Module Type Grid stabilization
Rated Power 840-1260 kW
Reliable and Scalable

Factory prepackaged and tested

  • Pre-engineered containershipped as a single unit with batteries, inverter, isolation transformer and other equipment installed.
  • Parallel ready - multiple modules may be used in parallel to increase total output up to 100+MW.

  • Designed to work with an array of renewable systems, including solar and wind
  • Seamless integration with Cat Microgrid Master Controller (MMC) allows for maximum renewable penetration and full asset control

When used with a generator set, the Cat PGS module will provide reserve power capacity to:

  • Decrease the transient voltage and frequency dips resulting from the application of large loads.
  • Enables highly-efficient lean-burn gas gensets to operate in island mode.

  • Protects against many typical power problems, including power failure, voltage sags/surges, and under/over frequency conditions.

  • Built-in controls for the charging and discharging of the energy storage equipment.
  • Static VAR compensator.
  • Four-quadrant output power factor control.
  • Automatic anti-islanding to meet UL 1741 and synchronization back to grid.

UL Listed to the following standards (certification and mark pending):

  • UL 9540
  • UL 1741 SB
  • CSA C22.2 No. 107.1/16
  • cULus mark
Declarations (pending):
  • CE Declaration of conformity
  • IEC60204-1